Sharpening is the process of creating or refining a sharp edge of appropriate shape on a tool or implement designed for cutting. Sharpening is done by grinding away material on the implement with an abrasive substance harder than the material of the implement, followed sometimes by processes to polish the sharp surface to increase smoothness and to correct small mechanical deformations without regrinding.
Contents |
The substance on the sharpening surface must be harder (hardness is measured on the Mohs scale) than the material being sharpened; diamond is extremely hard, making diamond dust very effective for sharpening, though expensive; less costly, but less hard, abrasives are available, such as synthetic and natural Japanese waterstones.
Very sharp knives sharpen at about 10 degrees (which implies that the knife's edge is a 20-degree angle). Typical knives are sharpened at 15 degrees. Knives that require a tough edge (such as those that chop) sharpen at 20 degrees or more. For an extremely durable edge (such as a chisel or drawknife), blades can be sharpened to 30 degrees.
Many implements have a cutting edge which is essentially straight. Knives, chisels, straight-edge razors, and scissors are examples. Sharpening a straight edge is relatively simple, and can be done by using either a simple sharpening device which is very easy to use but will not produce the best possible results, or by the skillful use of oil or water grinding stones, grinding wheels, hones, etc.
Sharpening these implements can be expressed as the creation of two intersecting planes which produce an edge that is sharp enough to cut through the target material. For example, the blade of a steel knife is ground to a bevel so that the two sides of the blade meet. This edge is then refined by honing until the blade is capable of cutting.
The extent to which this honing takes place depends upon the intended use of the tool or implement. For some applications an edge with a certain amount of jaggedness is acceptable, or even desirable, as this creates a serrated cutting edge. In other applications the edge must be as smooth as possible.
Sharpening straight edges (knives, chisels, etc.) by hand can be divided into phases. First the edge is sharpened with an abrasive sharpening stone, or a succession of increasingly fine stones, which shape the blade by removing material; the finer the abrasive the finer the finish. Then the edge may be stropped by polishing the edge with a fine abrasive such as rouge or tripoli on a piece of stout leather or canvas. The edge may be steeled or honed by passing the blade against a hard metal "steel" (which may be made of ceramic) which plastically deforms and straightens the material of the blade's edge which may have been rolled over irregularly in use, but not enough to need complete resharpening.
Different techniques are required where the edges are not straight. Special tools and skills are more often required, and sharpening is often best done by a specialist rather than the user of the tool.
Examples include: